Devel::TraceUse
---------------

Show the modules your program loads, recursively.

An apparently simple program may load a lot of modules. That's useful, but
sometimes you may wonder exactly which part of your program loads which module.

Devel::TraceUse can analyze a program to see which part used which module.
I recommend using it from the command line:

  $ perl -d:TraceUse your_program.pl

This will display a tree of the modules ultimately used to run your program.
(It also runs your program with only a little startup cost all the way through
to the end.)

  Modules used from your_program.pl:
     1.  strict 1.04, your_program.pl line 1 [main]
     2.  warnings 1.06, your_program.pl line 2 [main]
     3.  Getopt::Long 2.37, your_program.pl line 3 [main]
     4.    vars 1.01, Getopt/Long.pm line 37
     5.      warnings::register 1.01, vars.pm line 7
     6.    Exporter 5.62, Getopt/Long.pm line 43
     9.      Exporter::Heavy 5.62, Exporter.pm line 18
     7.    constant 1.13, Getopt/Long.pm line 226
     8.    overload 1.06, Getopt/Long.pm line 1487 [Getopt::Long::CallBack]

INSTALLATION

To install this module, run the following commands:

  $ perl Build.PL
  $ perl ./Build
  $ perl ./Build test
  $ sudo perl ./Build install

SUPPORT AND DOCUMENTATION

After installing, you can find documentation for this module with the perldoc
command.

  $ perldoc Devel::TraceUse

Alternately, read hack #74 in Perl Hacks, published by O'Reilly Media in 2006.

COPYRIGHT AND LICENCE

Copyright (C) 2006 chromatic.

Copyright (C) 2010 Philippe Bruhat (BooK), for the rewrite.

This program is free software; you can redistribute it and/or modify it
under the same terms as Perl itself.